Bushnell ONIX 110 - Manual (Page 56)

56
Troubleshooting
Problems Possible Solution
I pressed the power button
but the device doesn’t
switch off.
Make sure that you hold the power
button for two seconds to turn it off.
If the unit still doesn’t turn off, remove
the battery or the power source for five
seconds and install it again.
The unit does not respond
when I try to move the
cursor.
The map position may be latched. Check
if the symbol is shown in the bottom
right corner of the map page. If so, press
and hold a direction key to unlatch the
device.
What do I do to return to my
current position on the map
page after I have moved the
map?
Check if the symbol is showing in the
bottom right corner of the map page.
Press the ESC button to return to your
current position
The ONIX 110 fails to locate
my current position
.
Make sure that you are not in simulation
mode.
Make sure you are in an area with
no obstruction such as trees or tall
buildings.
The ONIX 110 requires synchronization
with at least three satellites to identify
with your current location. Once the
position has been identified, it requires
at least one satellite to maintain status.
If available satellite signals are too low in
orbit or all in a line, it may not be able to
locate your current location