Waring Pro ES1500 - Manual (Page 9)

9
4. Depending on the espresso spout used, place one or two
cups underneath the espresso spout and pull the control
lever (E) forward/towards the espresso cup symbol. Allow
espresso to dispense to the desired level (a standard shot
of espresso is approximately 1 ounce in size).
To stop dispensing, raise the control lever back to the
vertical standby position, as indicated by the dot. Just
a few seconds are needed for the espresso to flow down
into the cup(s). If the dispensing time is longer, this may
mean that the espresso is ground too fine or has been
pressed too much.
NOTE: Do not remove the ground espresso holder when
the control lever is in the dispensing position. Wait about
10 seconds after the espresso has been dispensed before
removing the holder. To remove, turn it slowly from right to
left to prevent water or espresso from splattering. DO NOT
reuse grounds.
Using a Pod
NOTE: Use with espresso pods only. DO NOT use with
single-serve coffee pods/cups.
To make espresso using pods, you must use the pod holder (N).
1. The pod must be centered and placed inside the pod filter.
It is recommended that you fold the corner inward.
2. Insert the pod holder onto the coupling seat (O). Be sure
that the grooves on the pod holder fit into the grooves of
the coupling seat. Rotate the handle towards the center
until resistance is felt. The handle will be secure when it is
at approximately at a 90° angle to the machine.
CAUTION: When attaching the pod holder, be sure to place
one hand on the cup warmer or the back of the housing to
keep the espresso maker secure while tightening the holder
onto the coupling seat (O). Do not touch external metal
parts indicated by the
X
marks, as they become very hot
during use (fig. 3).
3. Place one cup underneath the pod and pull the control
lever (E) forward/towards the coffee cup symbol. Allow
espresso to dispense to the desired level (a standard shot
of espresso is approximately 1 ounce in size).