Waring Pro ES1500 - Manual (Page 16)

16
Problem: Cause: Solution:
The espresso
maker does not
supply boiling
water. Air has probably
entered the circuit and
deactivated the pump. Make sure the water tank is
properly inserted and that
the water is not below the
minimum level.
The steam exit hole on
the steam/water wand
is clogged. Unclog any deposits that
may have formed in the
steam/water wand following
the cleaning & maintenance
instructions.
The espresso
maker does not
supply steam. There is too little
water in the water tank
and the pump cannot
reach it. Check that the water level
in the water tank is correct.
If necessary, fill it with cool
tap water.
The steam exit hole on
the steam/water wand
is clogged. Unclog any deposits that
may have formed in the
steam/water wand following
the cleaning & maintenance
instructions.
Espresso is
overflowing from
the edges of the
coupling seat. An excess amount of
ground espresso may
have been placed in
the ground espresso
holder, preventing it
from being inserted
correctly onto the
housing. Wait a minute or so and
slowly remove the filter
holder from the housing.
CAUTION: Any remaining
pressure could cause hot
espresso/water to splash.
Clean the coupling seat
with a sponge and repeat
the operation, placing
the correct quantity of
espresso in the holder.
Ground espresso
residue may be stuck
in the crema enhancer
inside of the ground
espresso holder. Wait a minute or so and
slowly remove the filter
holder from the housing.
CAUTION: Any remaining
pressure could cause hot
espresso/water to splash.
Clean the crema enhancer
with a sponge or toothpick,
being sure to release any
residue.
TROUBLESHOOTING
If there are severe problems with operation, immediately turn off
the machine and unplug it from the electrical outlet.