Waring Pro ES1500 - Manual (Page 13)

13
CLEANING & MAINTENANCE
Parts are not dishwasher safe; hand-wash only.
Cleaning the ground espresso holder (J)
Turn the filter counterclockwise and lift to remove it. Underneath
is the two-part crema enhancer silicone disk and plastic base.
Wash the silicone disk under running water, bending it slightly on
the side in order to free-up any residue. Wash the plastic base
under running water in order to free-up any residue. Wash and
remove any residue from the filter with a toothpick or sponge.
Be sure that all parts are dry before reassembling.
To reassemble, fit the silicone disk on top of the black base.
Place the crema enhancer into the ground espresso holder with
the black base on the bottom. Place the filter on top, fitting it into
the grooves of the ground espresso holder.
Cleaning the steam/water wand (Q)
With the machine in the ON and steam ready position, place the
wand in a pitcher of clean water and put the control lever into
steam mode. Pull the steam/water dispensing lever forward and
allow hot steam to dispense for a few seconds.
After the machine is completely cool, you can remove the end
of the steam/water wand. Turn it counterclockwise and pull
down. Run it through hot water, clearing it of any residue. Dry
thoroughly with a non-abrasive cloth before replacing.
Clean the outside of the steam/water wand with a sponge or
damp non-abrasive cloth after each use.
Cleaning the water tank (B)
Remove the water tank and wash it with cool water. Dry
thoroughly with a non-abrasive cloth before replacing.
Cleaning the grille and drip tray (R & S)
Remove the grille and drip tray from the machine and wash them
under running water, clearing any residue. Dry thoroughly with a
non-abrasive cloth before replacing.