Vigo VG06041 User Manual

Page 7

PLATE

HEX
SCREW

BRACKET
BODY

C. INSTALLING THE DOOR

Remove the rollers (#3) from the box, note that these are fully installed. Carefully unthread

the cap with a small head allen key. You will see a big hex screw, this is referred to as the

roller height adjustment screw.

Use the provided allen key to unscrew the adjustment screw and dismantle the roller. Place

the screw through door panel top holes and attach the two top rollers onto the door panel

(#5). [SEE FIG.7]

Place seal strip (#12) to the door panel on the side that closes to the wall. [SEE FIG.8]

4. Place the two top rollers and the door panel (#5) assembly onto the structural rail (#11).
Note that the rollers have a built-in mechanism that will provide adjustment for walls that are
not 100% perpendicular to the floor. If necessary, unscrew the adjustment screw and rotate
the individual roller. This will raise or lower the height that the roller sits on the structural rail.
Please refer to pages 13-16 for "Roller Adjustments to Accommodate Out of Square
Openings." Once the rollers are properly adjusted and the door sits flush against the wall in
the closed position, the adjustment will be complete. Fully tighten the adjustment screws
and re-install the roller caps. [SEE FIG.9]
4. Verify that the bottom of the door aligns with the notch in the bottom door guide (SEE FIG.

10).

5. Screw the two bottom rollers (#3) to the door panel.
6. Adjust the stoppers' position on the structural rail and tighten the hex screws.

MODEL VG06041

FIG. 5

FIG. 6