Vicor Javelin III - Manual (Page 10)

Javelin III Power Supply Operator’s Manual
Rev. 05/11/2012 Mission Power Solutions (760) 631-6846 [email protected] Pg. 10
Specifications
(Typical at 25C, nominal line and 75% load, unless otherwise specified)
General
Number of Outputs 1
Efficiency 75%
Safety Approvals N/A
MIL-STD’s 461E; 704E; 810E; 1399
Maximum Output Power 2400W, 115 VAC
3600W, 230 VAC
5400W, 230 VAC (Selected Output Voltages)
Input
Input 85-254 VAC, 47-500Hz
100-380 VDC
Line Regulation  0.2% from 10% load to full load
Inrush Current 90A rms. max. @ 115 VAC
180A rms. max. @ 230 VAC
60A rms. Max @ 230 VAC, three phase
Ride-Through Time 20 ms at 3600W load
Conducted EMI FCC Class A, EN 55022 Class B
MIL-STD-461E
Power Factor .99 (115 VAC 2400W load)
.95 (230 VAC 3600W load)
Transient Surge IEC 801-5 level 3
(Common Mode & Normal Mode)
Dielectric Withstand Primary to Chassis GND = 2121 VDC
Primary to Secondary = 4242 VDC
Secondary to Chassis GND = 50 VDC
Output
Parameter MIN. TYP. MAX. UNITS NOTES
Setpoint Accuracy 0.5 1 % of V
NOM
Load/Line Regulation 0.02 0.2 % of V
NOM
0% to 100%
Temperature Regulation 0.002 0.005 %C 20 to 100C
Long Term Drift 0.02 %1K hours
Output Ripple – pp:
2V, 3.3V 100 mV 20 MHz bandwidth
5V 2 % 20 MHz bandwidth
12-95V 1 % 20 MHz bandwidth
Trim N/A Consult Factory
Total Remote Sense Compensation 0.5 Volts 0.25V max. each leg
OVP Set Point 112 135 % of V
NOM
Recycle power
Current Limit 102 135 % of I max Automatic restart
Over-Temperature Protection Varies according to power level