Vicor VIPAC Array Family of DC-DC Converters Up to 750 Watts - Manual (Page 3)

Pin # Function
1-4 –Vin
5-7 +Vin
8 NC / PR bus
9 PE protective earth
10 – Remote enable
11-13 –Vin
14-17 +Vin
18 NC / PR bus
19 PE protective earth
20 + Remote enable
VA-J & VA-K configurations only
(300 & 375 Vin single Maxi &
single Mini)
Pin # Function
1-3 –Vin
4-6 +Vin
7 NC
8 NC / PR bus
9 PE protective earth
10 – Remote enable
11-13 –Vin
14-16 +Vin
17 NC
18 NC / PR bus
19 PE protective earth
20 + Remote enable
4 5
Factory Installed Micro LugMate
1 3
Input /Output Connections Input /Output Connections
1
11 20
10
Mating Connector
Vicor part # Amp part #
Housing 24795 2-794657-0
Contacts 24796 1-106529-2
Kit 24828
Input Connector
To disable output(s)
apply +5 Vdc
between pins
10 and 20 in the
polarity indicated
NOTE: Contacts accept #22-#18 Gage Wire.
Solder
Pin # Pad Function
1 – Vout
Rd Trim Down
SC Secondary Control
Ru Trim Up
3 + Vout
Consult design calculator for Rd/Ru trim resistor
values located at vicorpower.com.
Pin # Conn. Function Mating Conn.
1 – Vout
J4-1 – Vout
J4-2 – Sense
J4-3 Secondary Control P/N 16385
J4-4 + Sense
J4-5 + Vout
5 + Vout
*Removable
Jumper
*Removable
Jumper
#10-32 torque 16 in. lbs.
J4
1
5
Factory Installed
*Removable jumpers in J4 are factory installed for
local sensing. For remote sensing the +Sense pins
should be tied to the same point on the +Out power
bus; the -Sense pins should be tied to the same point
the -Out power bus.
*
P/N 16385
1
5
#4-40 torque 4 in. lbs.
Discrete Output Parallel Output
Shown with the output(s) of two
modules connected in parallel
using factory installed bus bar.