UVP ChemiDoc-It TS2 Imagers - Manual (Page 9)

GelDoc-It
TS2
and ChemiDoc-It
TS2
Imagers 9
Setup Instructions
Components
When unpacking the GelDoc-It
TS2
and ChemiDoc-It
TS2
, the following items will be included:
1. GelDoc-It
TS2
or ChemiDoc-It
TS2
darkroom
2. Ethidium bromide (EtBr) emission filter
3. Transilluminator
4. Power cable
5. Keyboard and mouse
6. VisionWorksLS Software (included with ChemiDoc-It
TS2
only)
7. Supporting documentation
When unpacking and setting up the darkroom, two people are required to move the darkroom.
Place the darkroom on a flat surface which can provide adequate support for up to 100 pounds.
WARNING: Do not attempt to perform any setup procedures while the system is plugged in or powered on
unless otherwise instructed.
CAUTION: Do not install the system in areas with high moisture, dust or high temperatures. Keep the
equipment away from motors or any other large magnetic equipment apparatus. This system is designed for
indoor use only.
Connecting the Power Cables
1. Plug the main power cable into the back of the
darkroom and the other end into a surge-
protected power outlet.
Note: It is recommended to leave the power
switch on the back of the system in the ON
position except when the system will not be
used for an extended period of time (one day or
longer).
Note: Do not position the system so that it is difficult to access the power cable and operate the
main power switch at the back of the unit.
2. Inside the darkroom, place the transilluminator on the roll-out tray. Connect the transilluminator to
the internal power jumper cable.
3. If installing the LED White Light Plate, place the plate on top of the UV transilluminator and connect
the power cord coming from inside the darkroom to the back of the Plate.
4. If installing epi UV handheld lamps, place the lamps in the brackets located at the top of the
darkroom. Plug the handheld lamps into the outlets provided inside the darkroom. Place the power
switches located on the handheld lamps in the ON position.