UVP EpiChemi II Darkroom - Manual (Page 5)

Transilluminator Tray
The slides forward and back for easy access to the transilluminator surface. See transillu-
minator documentation for specific transilluminator operating instructions.
NOTE: When using the transilluminator with the darkroom door open, UV exposure safety
precautions, including protective eyewear and clothing, must be observed to prevent harm-
ful ultraviolet radiation exposure.
Set-Up and Operating Instructions
DO NOT ATTEMPT TO CONNECT ANY WIRING WHILE THE EQUIPMENT IS
CONNECTED TO ANY POWER SUPPLY.
CAUTION!
Do not install the EpiChemi II Darkroom in places with high moisture, dust or high
temperature.
Do not use any oil or petroleum based cleaner for the cabinet. Use only mild soap or
detergent solution for cleaning. Ensure that the system is turned OFF during cleaning.
Set-Up
1. Connect the camera and mount to the darkroom as
specified in the camera documentation manual.
2. Connect the power cord to the main power port which is
located on the back-top of the darkroom cabinet.
Operation
1. Turn on the master power switch on the front of the
darkroom cabinet. Once the power is switched on, power
is applied to all internal components and to the power port
for the jumper power cable that supplies power to the
transilluminator.
2. The Transilluminator Control knob has three options:
Safety Switch - Transilluminator safety control switch
automatically turns the transilluminator off when door opens
which prevents the user from exposure to UV
Always Off - This button setting puts the transilluminator in
Off mode. Use this switch when the transilluminator is not
required such as when capturing chemi blots.
3
EpiChemi II Darkroom