Unisteer 8010910-01 Mustang Rack & Pinion Kit 1965-Early 1967 - Manual (Page 8)

pg. 8
655760
17. Once removed, install the new pump and bracket in place and attach it with supplied
hardware and standoffs provided in kit.
18. The power steering lines have fittings on them that can only be installed one way at the pump.
If you are unclear at all you can trace the lower port on the rack and pinion following the lineup to
the pump. This is the pressure line. The top port at that rack is the return port, which goes to the
plastic reservoir. Be sure to tighten the clamp.
19. When your lines are connected and the top bolt on the pressure port is torque to 20 ft. lbs.
You may top off the fluid in the reservoir and start the car.
20. Let the car idle and turn the wheels back and fourth slowly to remove air from the system.
21. Shut the car off and make sure you have no leaks and the level is full.
22. When your install is complete it will be necessary to have an alignment done.
Small Block Pump
Small Block Pump Big Block Pump