Unisteer 8010910-01 Mustang Rack & Pinion Kit 1965-Early 1967 - Manual (Page 4)

pg. 4
655760
5. Remove the column tube assembly.
6. From under the car remove the gear box and shaft assembly, (all one piece.)
7. Place your column tube on a flat surface and measure from the very bottom of the column
towards the steering wheel 3-
1/8”. Mark the column check the measurement again and cut the
tube off squarely at you mark. Next install the supplied column bearing into the bottom of the
tube by tapping it into place with a hammer.
8. Once you have this done install the appropriate floor plate provided in your kit using the
hardware provided. Slide the floor plate over the column tube with the clamp and install the
column through the firewall and bolt back in place. Attach the new floor plate with supplied
hardware and complete the installation.