Unisteer 8010910-01 Mustang Rack & Pinion Kit 1965-Early 1967 - Manual (Page 3)

pg. 3
655760
The first step is to disassemble and remove the stock steering linkage, steering box and column.
1. Raise vehicle and support it on stands. Note be sure not to put the stand in a location by the
stock round cross member.
2. Remove the cotter pins and nuts from outer tie rod ends and remove tie rods from spindles.
Disconnect the center link and idler arm assembly from the frame and remove the entire steering
linkage.
3. Remove bolts retaining the gear box to the frame and remove the box. If equipped remove the
power steering pump, brackets and lines. All the pieces removed will not be used.
4. The steering column tube needs to be modified by first removing the steering wheel and the
column tube bolts. Then disconnect the wiring, making note of their location to ease
reinstallation.