Unisteer 8001120-01 Mustang 1965-Early 1967 - Manual (Page 7)

pg. 7 655850
13. Slide the provided stainless clamp over the column tube and put the column tube through the plate
and secure it back in place using the stock bolts and bracket you removed earlier. Once in place
tighten the clamp over the ears of the plate to the column to secure the lower portion of the column.
14. Next install the supplied column shaft into the column tube and feed down through the bearing.
Install the tapered pinch ring, removed from the stock shaft, to hold the shaft in place.
15. From under the hood install the supplied brass washer over the shaft and install the u-joint on the end
and torque the bolt to 40lbs ft. Next install the pinion u-joint over the pinion on the rack and slip the
supplied piece of shaft between the upper and lower u-joint. Some trimming maybe required. Once
installed torque pinion bolt to 40 lbs ft.
16. Verify that your rack is centered and set your toe adjustment by eye trying to keep the front wheels
straight. Once you have this done install your steering wheel in place and tighten to 30 lbs ft.
Reinstall the horn pad and take the car to a professional for an alignment. Enjoy the drive.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/20/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.