Unisteer 8001120-01 Mustang 1965-Early 1967 - Manual (Page 10)

pg. 10 655850
6. Install the brass bearing collar from the old steering shaft onto the new steering shaft and slide the new
shaft through the column tube and wiggle through the bearing hole. Then install the steering wheel and
finger tighten the nut only.
7. From under the hood you can now install the provided brass washer and shaft u-joint to the splined
end. Once the brass washer and u-joint are in place and tight, finish securing the steering wheel. This
will seat the tapered piece in your column and you should have minimal movement up and down on the
steering wheel.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/20/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.