Unisteer 8001120-01 Mustang 1965-Early 1967 User Manual
Page 6
pg. 6
655850
10. Once the bracket is installed you can now connect your outer tie rods to your steering arms. Note the
kit has been shipped to you with 2 sets of tie rods. You need to determine which ones you use by
comparing the taper size of your stock tie rod. Be sure that the tie rod you select fits your steering
arm tightly and locks on the taper.
11. Next, you need to modify the column tube assembly. Measure and mark from the bottom of the
column tube 3 1/8” up and cut off the tube. Install supplied column tube bearing in the bottom of the
column; tap into place with hammer by walking it around the O.D. of the bearing until it stops against
the lip.
12. Put the supplied column plate against the firewall from inside the car and secure it with the
supplied sheet metal screws.