Unisteer 8011530 Corvette Power Rack & Pinion Kit 1958-1962 - Manual (Page 10)

Page 10 656460
16. Route the power steering lines as shown in the below photos. The pressure line is a #6AN line
measuring 21”; it goes from the power steering pump to the lower port on the Rack. The Return line
is a #6AN line measuring 17 ½” and goes from the upper port on the rack to the smaller fitting on the
bottom of the reservoir. Last the Reservoi
r line is a #10AN line measuring 26” and goes from the
reservoir to the back of the power steering pump.
17. Make sure all lines are free from rubbing anything that can harm them and tighten all the fittings.
18. Align your toe as close as possible and tighten all nuts.
19. You can now fill the pump with power steering fluid. Start and run the engine for 5 seconds and shut it
off. Do not turn the steering wheel. Top off the fluid and restart vehicle. While running slowly turn the
wheel slightly right to left and shut vehicle off. Check for leaks at this point and top off fluid level
again. Start vehicle and turn right to left to bleed air from system. Check for leaks. Verify fluid is
topped off and get vehicle to a qualified shop for an alignment.
20. At this point, double check to make sure all nuts and bolts are tight and get the vehicle to a qualified
shop for an alignment. Toe is adjusted by leaving outer tie rod loose at jam nut and by just turning
inner tie rod end.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created 2/17/2012
Last Revised 6/26/2014
Copyright © 2011 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.