Ultralife CH0007 - Manual (Page 20)

CH0007 Operation Manual
Newark, New York | 315-332-7100 | Fax: 315-331-7800
©2010 Ultralife Corporation • www.ultralifecorp.com • All specific subject to change without notice
The information contained herein is for reference only and does not constitute a warrant of performance • 30 SEP 10 UBI-5166 Rev: A
Page 20 of 25
5 PACKAGING AND SHIPPING INSTRUCTIONS
The charger can be mounted to a vehicle or a rack for normal use. If it needs to be transported other
than in a vehicle, please observe the following guidelines.
 Whenever possible pack the charger in the original packing material as shown in Fig. 13.
 The charger should be packed such that it does not move about within the container. Failure
to do so might result in damage to charger exterior.
 Ensure that charger packing media has visible markings on the exterior that indicate proper
orientation.
 Use proper support. Whenever possible give full bottom support to the charger.
 Use padded material to cover the lid surface to protect it from falling objects during
transportation.
 The charger power cord, if packed with charger should be properly secured. Failure to do so
can result in damage to contact points.
 Always rest the charger on its bottom face. NEVER INVERT THE CHARGER AND REST IT
ON ITS LID.
 Do not stack unpacked chargers on each other. Stacking chargers one over the other may
damage charger lid surface.
 A fully packed charger is bulky and heavy. Use ‘team lift’ strategy to move the charger or use
appropriate moving equipment.