Regency Liberty L390PB Medium Gas Insert - Manual (Page 23)

L 390 PB-2 / HZI 390 PB-2 Direct Vent Gas Insert
23
INSTALLATION
9. Bundle excess wires and power cord - with the exception of the wire
marked receiver.
Receiver wire requires enough slack to reach the front left of the unit
to be connected to the receiver.
Secure wires with cable ties installed in previous step.
Additionally secure wires with a wire clip to be installed in location
shown below.
10. Install receiver onto backing plate with 2 screws and plug in
receiver cord shown in Step 9.
11. Connect receiver wire from the wiring harness to the back side of
the remote receiver as shown below
Receiver Wire
Grommet
Cable Tie
Wire Clip
Left
Right
Cable Tie Cable Tie
12. Bundle excess receiver wire using the 4th cable tie and secure to
the front left of the fi rebox as shown below.
13. Plug the 10 foot extension cord into the FCM extension cord as
shown below.
14. Install a grommet on power cord near the three prong plug
connection made in previous step and secure to the faceplate as
shown below.
Note: 3 prong plugs should be left behind the faceplate after
installation is completed.