Regency Plateau PTO60 Outdoor Gas Burner - Manual (Page 26)

26
Regency Plateau™ PTO30 Outdoor Gas Fireplace
INSTALLATION
OPTIONAL PANELS:
1. Bend tabs on top fl ange of side panel to 90º.
1. Slide propane drawer into tracks (previously installed in Step 9) until
slides clip at end of track.
NOTE: Only three (3) of the four (4) supplied vents need to be installed
as the propane drawer includes a vent.
OPTIONAL PROPANE DRAWER:
Diagram 2 - Top Panel
screw locations
Diagram 1 - Propane Drawer Install
Diagram 1 - Bend tabs to 90º
Diagram 2 - Lower tabs on panel aligned with base
Diagram 3 - Bend tabs fl at, panels is supported on
headers.
2. Position panel - lower tabs line up with indents in base.
3. Bend tabs fl at, the side panel will then be supported to allow the
installation of the top panel.
4. Install top panel with six (6) screws in locations shown below.
Flattened
Tabs
Header
(Opacity
reduced)