Regency Plateau PTO28CIT Outdoor Gas Firetable - Manual (Page 22)

22
Regency PTO28 City Table Outdoor Gas Fireplace
22
OPERATING INSTRUCTIONS
FIRST FIRE
The fi rst fi re in your decorative gas appliance is part
of the paint curing process. To ensure that the paint
is properly cured, it is recommended that you burn
your decorative gas appliance for at least one (1)
hour the fi rst time you use it.
When fi rst operated, the unit will release an odour
caused by the curing of the paint, the burning off of
any oils remaining from manufacturing.
The glass surround may require cleaning after the
unit has cooled down.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
OPERATING
INSTRUCTIONS
1. Read and understand these instructions before
operating this appliance.
2. Check to see that all wiring is correct and
enclosed to prevent possible shock.
3. Check to ensure there are no gas leaks.
4. Verify log placement. If the pilot cannot be
seen when lighting the unit, the logs have been
incorrectly positioned.
5. The unit should never be turned off, and on
again without a minimum of a 60 second wait.
LIGHTING PROCEDURE
1. Remove cover.
2. Turn on gas to appliance.
3. Turn ON/OFF switch to ON.
4. Use a long lit match or BBQ lighter - position ignition
source above burner tube.
5. Push in gas control button and hold (located left of ON/
OFF switch).
6. Once appliance is lit - hold button for an additional 30
seconds.
7. After 30 seconds - release gas control button.
If after 30 seconds appliance does not stay lit:
a) Turn ON/OFF switch to OFF.
b) Wait 5 minutes.
c) Repeat steps 3-7.
SHUTDOWN
PROCEDURE
1. Turn off ON/OFF switch.
2. Shut off gas supply to appliance.
3. Allow unit to cool—reinstall cover.
DO NOT place hand over burner
when lighting.