Regency Plateau PTO28CIT Outdoor Gas Firetable - Manual (Page 18)

18
Regency PTO28 City Table Outdoor Gas Fireplace
INSTALLATION
BURNER PACKAGES
Unit Glass Crystals Only *Glass Crystals + Volcanic stones¹
PTO28 5lbs 5lb glass + 14 stones- recommended
NOTE: * Glass Crystals are available in 1lb and 5lb bags.
¹ Glass Crystals to be installed on the burner prior to installing stones.
Basalt Volcanic Stones are measured by weight not quantity. Each bag contains 15 lbs of stones, however the exact quantity
and size vary. Sizes vary between 2" - 3"
Evenly spread the Glass Crystals and optional Basalt Volcanic Stones over the burner. Ensure the crystals (or stones) do not overlap too much as this will
effect the fl ame pattern.
IMPORTANT NOTE:
Only the supplied approved Glass Crystals and Basalt Volcanic stones are to be used with these fi replaces. Use of any other type of glass crystals or stones
can alter the unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.
Important: Glass crystals must NOT be installed in the shield. Shield must remain free and clear.
When using Basalt Volcanic Stones DO NOT cover the shield and thermocouple area.
1 . Spread crystals over burner. Base
and burner tube should not be
visible when complete, except area
immediately in front of shield and
thermocouple area.
3. Basalt Volcanic Stones shown
stacked over the burner and crystal
base.
4 Ensure Stones do not block the
shield and thermocouple.
2. Ensure Crystals do not block the
shield and thermocouple.
NOTE: Basalt Volcanic Stones are NOT to be placed anywhere on the Pilot assembly area.
Glass Crystals to be installed on the burner prior to installing stones.
NOTE: Correct fi nal glass installation of Crystals as shown in step 1.
The Burner (except area immediately in front of shield and
thermocouple area) should not be visible when the fl ame is out.
GLASS CRYSTAL / BASALT VOLCANIC STONES INSTALLATION
Shield
Correct install Incorrect install