Safety label, Duplicate s/n, Copy of safety decal for p36d-1 – Regency Panorama P36D Medium Gas Fireplace User Manual

Page 6

Regency

P36D-1 Zero Clearance Direct Vent Gas Fireplace

SAFETY LABEL

This is a copy of the label that accompanies each P36D-1 Zero Clearance Direct Vent Gas Fireplace. We have printed a copy of the contents here for your
review. The safety label is located on the front inside base of the unit, visible when the bottom louver is open.

NOTE: FPI units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one.

COPY OF SAFETY DECAL FOR P36D-1

DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE

306

DOOR SEAL: Please

check that the door is

properly sealed

Minimum Clearances to Combustibles /

Degagement Minimum De Materiaux Combustibles

Serial No./ No de serie

918-500a

The "Bay Louvers"

used with the Bay Glass option

MUST

MAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE.

Duplicate S/N

32"

Ceiling

all

(See Instruction Manual for

detailed instructions)

Electrical supply / Électrique 115VAC, 1.13 A, 60Hz.

VENTED GAS FIREPLACE HEATER -NOT FOR USE WITH SOLID FUELS.

NE PAS UTILISER AVEC DU COMBUSTIBLE SOLIDE.

FOYER AU GAZ À ÉVACUATION -

This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation Code, CSA B149.1.
This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United
States, or when such a standard is not applicable, ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See owner's manual
for details.
Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel Gas Code ou CSA-B149.1 en vigueur.
Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured Home Construction and Safety Standard. Si ces
normes ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles.

For use with glass doors certified with the appliance only

This vented gas fireplace heater is not for use with air filters.

Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.

Fan (Part # 432-917) Optional Bay Window (Part #510-930) Option: HeatWave Kit # 946-556

Cet appareil doit être utilize uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U. seulement) installée à demeure si les règlements
locaux le permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est fournie.

Pour utilisation uniquement avec les portes en verre certifiées avec l'appareil

Made in Canada/

Fabrique au Canada

FPI Fireplace Products International Ltd.Delta, BC, Canada

Listed:
Certified for/Certifi e pour:
Tested to:
WN# 16462

CANADA and U.S.A.

CGA-2-17-M91, ANSI Z21.88a-2007 / CSA 2.33a-2007

VENTED GAS FIREPLACE HEATER / FOYER AU GAZ À ÉVACUATION

APPAREIL FONCTIONNANT AU GAZ PROPANE
CONCU POUR ETRE POELE:
Pression d'allimentation minimum
Pression à la tubulure d' chappement lev e
Pression à la tubulure d' chappement basse
Grandeur de l'injecteur
D bit

minimum selon

D bit

maximum selon

l'altitude

Calorifique
Calorifique

Modéle P36D-LP1

й
й

NATURAL GAS:

Minimum supply pressure
Manifold pressure high
Manifold pressure low
Orifice size
Minimum input
Maximum input
Altitude

Model P36D-NG1

PROPANE:

Minimum supply pressure
Manifold pressure high
Manifold pressure low
Orifice size
Minimum input
Maximum input
Altitude

Model P36D-LP1

WC(1.25 kPa)

3.8"

WC(0.95 kPa)

1.1"

WC(0.27 kPa)

# 37

DMS

15,500 Btu/h

(4.54 kW)

0-4500 ft/pi(0-1372 m)

30,000 Btu/h

(8.79 kW)

12"

WC(3.00 kPa)

11"

WC(2.74 kPa)

2.9"

WC(0.72 kPa)

# 52

DMS

15,000 Btu/h

(3.96 kW)

0-4500 ft/pi(0-1372 m)

30,000 Btu/h

(7.91 kW)

APPAREIL FONCTIONNANT AU NATURAL GAZ
CONCU POUR ETRE POELE:
Pression d'allimentation minimum
Pression à la tubulure d' chappement lev e
Pression à la tubulure d' chappement basse
Grandeur de l'injecteur
D bit

minimum selon

D bit

maximum selon

l'altitude

Calorifique
Calorifique

Modéle P36D-NG1

й
й

Model/Modele:

P36D-NG1

Model/Modele:

P36D-LP1

0" Clearance to
combustibles from:

Mantel Clearances from Top:

Side Wall Clearance
from Side Facing

Alcove Clearances:

Minimum Vent Clearances:

Top, sides, bottom and rear of unit

(A) Min. 7" (177mm)

B) 6" with Flush or Bay Front
B) 8" with Barcelona Trim

Alcove approved for
Bay & Flush Louvers.

Max. Depth 36" (914mm)
Min. Width 48" (1219mm),
Min. Height 72" (1229mm)

Horizontal Top

2-1/2" (64mm)

Horizontal Side
Horizontal Bottom 1-1/2" (38mm)

1-1/2" (38mm)

For the State of Massachusetts, installation
and repair must be done by a plumber or
gasfi tter licensed in the Commonwealth of
Massachusetts.

For the State of Massachusetts, fl exible
connectors shall not exceed 36 inches in
length.

For the State of Massachusetts, the appli-
ances individual manual shut-off must be a
t-handle type valve.

The State of Massachusetts requires the
installation of a carbon monoxide alarm in
accordance with NFPA 720 and a CO alarm
with battery back up in the same room where
the gas appliance is installed.