Regency Panorama P36D Medium Gas Fireplace - Manual (Page 36)

36
Regency ® P36D-1 Zero Clearance Direct Vent Gas Fireplace
INSTALLATION
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
1) Shut off the gas supply.
2) Remove the louvers (and bay door if it is
installed).
3) Open the fl ush door and remove the
door.
4) Remove the logs and embers (if already
installed).
Remove the 2 screws, push Burner Assembly
to the left and lift out.
6) Pull off the pilot cap to expose the pilot
orifi ce.
7) Unscrew the pilot orifi ce with the allen
key; then replace with the LPG pilot
orifi ce and the pilot cap, provided in the
kit.
8) Remove burner orifi ce with a 1/2"
wrench. Use another wrench to hold on
to the elbow behind the orifi ce. Discard
orifi ce.
Burner Orifi ce
Each Kit contains one LPG
Conversion Kit and one DC
Sparker Kit.
Conversion Kit Contains:
Qty. Part #
Description
1 904-390 Burner Orifi ce #52
1 904-529 5/32" Allen Key
1 918-590 Decal "Converted
to LPG"
1 908-528 Red "LPG" label
1 910-037 LPG Injector
(Pilot Orifi ce)
1 918-481 Instruction Sheet
5) Remove the 2 screws holding the Burner
Assembly to the fi rebox base. Push the
Burner Assembly to the left and lift out.
DC Sparker Kit Contains:
Qty. Part # Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External Star
1 904-330 Nut 8-32 Hex
2 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4 Pan
Head
2 904-553 Screw #8 x 1/2 Type "B",
Black Oxide
1 910-073 Spark Generator Battery
Holder
1 910-074 Spark Generator Switch
C/W Wire
1 910-078 Battery Size AA
Energizer En91
2 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power Cord
Ground 30 in.
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
Installation of LPG
Conversion Kit:
For P36D-1 / P36-4 Only:
For U32-5 Only:
5a) Remove the grate by removing the
screws on each side of the grate.
Remove the 2 screws,
push Burner Tray to the left, and lift off.
Remove the 2 screws
holding the grate in position.
5b) Remove the Burner Tray by removing
the screws on each side of the tray.
Push the tray to the left and lift up.
IMPORTANT
Before re-installation of the burner (once
the LP conversion is complete), the air
defl ector must be installed. See step 18a.
CONVERSION KIT# 514-969 FROM NG TO LP
for P36D-1 / P36-4 / U32-4 / U37-1 using SIT 820 NOVA Gas Valve