Regency Panorama P36D Medium Gas Fireplace - Manual (Page 54)

54
Regency ® P36D-1 Zero Clearance Direct Vent Gas Fireplace
54
REGENCY ® OPTIONS
FULL SCREEN DOOR INSTALLATION
1) Before beginning the installation, remove the Screen Doors from the
Full Screen Door Frame by fully opening the doors and lifting up off
of the hinges. See important note in step 7.
Inner
Cut-Outs
Bottom
Flange
NOTE: Should the fi nished wall protrude beyond the face of the unit,
you can accommodate up to 1/2" depth.
Simply push in the Full Screen Door Frame until it aligns against
the fi nished wall. Secure Top Flange of Full Screen Door Frame as
described in step 2.
For the Bottom Flange of the Full Screen Door Frame, push the
bottom of the Frame until it aligns with the wall. Use the inner cut-outs
to secure the base of the Frame using the 2 x Hex Head Drill Point
Screws provided.
Backside of Full Screen
Door Frame Shown
Inside Top
of Outer
Frame
Hinge
Bracket
Inner Hinge
Bracket Screw
2) Full Screen Door Frame Installation
a) Before attaching the Full Screen Door Frame to the unit, loosen the
left and right side #8 Philips Head Screws located on the inside top
of the outer frame of the appliance. Also remove the center screw.
Loosen the #8 Philips Head Screw on the inner side of each hinge
bracket as shown below.
b) Slide the cut-outs in the Top and Bottom Flange of the Full Screen
Door Frame under the screw heads which were loosened in step
2a. Once the Frame is in place, tighten the screws to secure. Also
re-secure the top center screw through the oblong hole.
Backside of Full
Screen Door
Frame Shown
Cut-Outs
Bottom
Flange
Cut-Out
Top
Flange
Cut-Out
Oblong Hole