Stack-On PC-650 User Manual

Page 2

40263-1110

● For security you must program

your own combination after opening

the case.

● Record this new combination on

this form.

PROGRAMMING YOUR OWN

ELECTRONIC COMBINATION

OPENING THE CASE USING

YOUR COMBINATION

Press the Reset Button (5) located inside the case. Two “beeps” will

sound.

1. Enter your combination using the buttons. If 2 “beeps” sounds and the

green light goes on, the door will open. If an incorrect combination is

entered 4 short “beeps” will sound.

Example: (RIGHT) - (LEFT) - (CENTER) - (LEFT) - (RIGHT)

Enter your own 3-8 button combination by pressing any combination of

the 3 buttons. NOTE: A “beep will sound when the button is successfully

pushed.

3. Press the Reset Button again. After two “beeps” your new

combination is recorded.

NOTE: If you enter a wrong combination 3 times, the control pad

will lock out for 5 minutes.

IMPORTANT

Keep keys and your combination number in a secure place, away

from children. Keep this record of your serial number and

combination in a secure place separate from your case. To order a

replacement key set, follow the instructions on the attached form.

STACK-ON PRODUCTS COMPANY

P.O. BOX 489

WAUCONDA, IL 60084

To secure the case to a fixed object, loop

the cable around the object and place the

cable’s small end into the notch on the side

of the case. Locking the case will secure

the cable end in the case.

SECURING THE CASE WITH THE CABLE

To close the case, push the cover closed until locked.

Reset Button