Stack-On GCD-9216-5 4254-0707 User Manual

Page 3

STACK-ON PRODUCTS COMPANY

P. O. BOX 489

WAUCONDA, IL 60084

INSTALLATION OF SCOPE STAND-OFF

NOTE: The scope stand-off will function properly for many combinations of guns with

scopes.

Screw the scope stand-off into the pilot hole of the barrel rest. (See figure 9)

Place the bottom pad (L) in the right compartment. (See figure 8)

If you have installed the shelves, place the shelf pads (M) on the shelves and on the

bottom of the left compartment. (See figure 8)

If you have installed the additional barrel rests in the left compartment, place 2 shelf

pads (M) on the bottom of the compartment.

IMPORTANT

Keep keys away from children. Keep this record of your serial and key

numbers in a secure place separate from your security cabinet. If you

lose your keys you will need this information as a reference for obtaining

new keys. To order a replacement key set, follow the instructions on the

attached form.

INSTALLATION OF GC-900-5 PISTOL-AMMO CABINET ON TOP OF

SECURITY CABINET

NOTE: We recommend that security cabinet be installed as described above.
IMPORTANT: Install the shelves before mounting the cabinet to a wall.
Remove the top hole plugs from the cabinet by pushing out from the inside of the cabinet.
Place the GC-900-5 on top and assemble with (2) 1/4-20 nuts and bolts. Do not tighten

bolts. (See figure 10)
Drill (4) 3/16" pilot holes into the wall studs and secure the GC-500-5 cabinet to the wall

using (2) lag bolts and washers. (See figure 10)
Tighten the (2) bolts that connect the cabinets.

4254-0707

3 15