beautypg.com

Stack-On GC-914-5 4320-0707 User Manual

Page 2

background image

9

STACK-ON PRODUCTS COMPANY

P. O. BOX 489

WAUCONDA, IL 60084

4320-0707

2 12

8

INSTALLATION OF SCOPE STAND-OFF

NOTE: The scope stand-off will function properly for many combinations of guns with

scopes.

Screw the scope stand-off into the pilot hole of the barrel rest. (See figure 8)

IMPORTANT

Keep keys away from children. Keep this record of your serial and key

numbers in a secure place separate from your security cabinet. If you

lose your keys you will need this information as a reference for obtaining

new keys. To order a replacement key set, follow the instructions on the

attached form.

FOAM INSTALLATION

NOTE: Mount the cabinet to the wall or floor before proceeding with the foam installation. Refer to the Cabinet Mounting Instructions.
Remove the upper 2" of the backing from the rear foam pad (C). Gage to the bottom edge of the rear barrel rests in the cabinet and remove the remaining

backing while pressing the foam in place. (See figure 5)
Apply the side pads (D). Gage foam padding to the bottom edge of the side barrel rests and work down. (See figure 6)
Place the bottom pad (E) in the bottom of the cabinet. (See figure 7)

6

D

5

C

7

E

INSTALLATION OF GC-900-5 PISTOL-AMMO CABINET ON TOP OF

SECURITY CABINET

NOTE: We recommend that security cabinet be installed as described above.
IMPORTANT: Install the shelf before mounting the cabinet to a wall.
Remove the top hole plugs from the cabinet by pushing out from the inside of the cabinet.
Place the GC-900-5 on top and assemble with (2) 1/4-20 nuts and bolts. Do not tighten

bolts. (See figure 9)
Drill (4) 3/16" pilot holes into the wall studs and secure the GC-500-5 cabinet to the wall

using (2) lag bolts and washers. (See figure 9)
Tighten the (2) bolts that connect the cabinets.