Sensaphone IMS-4000 Upgrade instructions - Manual (Page 9)

IMS-4000 Software Update Notice
9
Version 2.82 (March 24, 2005)
• Web page now allows programming changes depending on permissions level.
• Improved web server operation when viewed continuously.
• Corrected e-mail issue when host name or Profile name contained a comma.
• Corrected clock issue for Mid-Atlantic time zone setting.
Version 2.80 (February 23, 2005)
• Corrected web server security issue where service was still running when disabled by the user.
• Fixed web page event log messages to match those shown in ConsoleView.
• Corrected problems with sending camera images after a camera has failed to respond.
• Corrected a problem where alarm dialout calls did not stop after the maximum number of calls
were attempted.
• Corrected problem that caused Nodes to reconnect as “new” instead of maintaining their existing
programming.
• Corrected an issue that resulted in repeated calls being made if e-mail could not be sent.
Version 2.77 (August 10, 2004)
• Added call-in acknowledgement feature.
• Added support for configurable SNMP trap levels.
• Corrected time synchronization issue when timeserver is unavailable.
• Updates “Last acknowledge” times to current time if “Last Acknowledge” occurred prior to “Last
Alarm.”
• Compatible with MIB version 1.2.
• Corrected holiday scheduling issue.
• Corrected blind dialing option.
• Corrected issue with SNMP Trap message.
Version 2.59 (October 20, 2003)
• Added support for Panasonic network camera.
• Added ability to reorder Profiles and Contacts.
• Added ability to remotely reconfigure network settings for both Hosts and Nodes.
• Added colored bullets to IMS-4000 web page to indicate OK/Alarm status.
Version 2.54 (July 1, 2003)
• Redesigned web page.
• Added periodic dialtone test.
• Revised subject line for alarm e-mails.
• Added support for 128 Cameras.
• Two-way e-mail command format is now less sensitive to upper/lower case letters.
• Corrected issue regarding alarms that never clear.
• Enhanced flash upgrade utility.
• Compatible with MIB version 1.1
Version 2.49 (March 11, 2003)
• Added support for Camera Snapshot in alarm response.
IMS-4000 Software Update Notice