Sensaphone IMS-4000 Upgrade instructions - Manual (Page 14)

14 IMS-4000 Software Update Notice
Version 3.10 (August 23, 2005)
• Corrected network issues regarding the Gateway and Broadcast settings.
• Removed error messages that appeared at the serial port.
• Added network debug option menu.
Version 3.06 (June 13, 2005)
• Corrected routing issue if host and node are on different subnets.
Version 3.0.5 (May 12, 2005)
• Suppressed system messages appearing at the serial port.
• Reduced power consumption by disabling unused processor options.
Version 3.0.4 (April 7, 2005)
• First firmware release for nodes supporting 10/100 Mbps.
10 Mbps model
Version 2.59 (April 1, 2006)
• Corrected IP Alarm issue when the device status changes from Route Down to Ping Timeout.
Version 2.58 (November 10, 2004)
• Changed battery alarm routines to detect if the batteries are disconnected.
• Changed humidity sensor range to limit values between 0 and 100%.
Version 2.57 (June 3, 2004)
• Corrects issue regarding unacknowledged IP Alarms if host reboots.
Version 2.38 (October 20, 2003)
• Added ability to remotely reconfigure network settings.
• Improved battery management functions.
• Corrected serial port erroneous character display issue.
Version 2.22 (June 13, 2003)
• Corrected issue regarding sensor trouble alarms.
Version 2.21 (March 11, 2003)
• Corrected issue regarding return-to-normal alarms when reset time is also enabled.
Version 2.20 (November 12, 2002)
• Corrected problem when IP alarms tripped after Reset Time expired.
Version 2.19 (September 20, 2002)
• Added support for the IMS 4–20mA Bridge.
Version 2.16 (August 28, 2002)
• Resolved issue when removing a sensor for more than a minute and then reconnecting the same
sensor.
• If an IP alarm occurs a second time before the initial alarm gets acknowledged, then a redundant IP
alarm is logged in the event history.
Version 2.10 (July 12, 2002)
• Added support for Alarm on return-to-normal for environmental inputs.
• Changed firmware version style to 0.0 (major.minor).
• Resolved PowerGate initialization issue.