Sensaphone IMS-4000 Upgrade instructions User Manual

Page 7

IMS-4000 Software Update Notice

• Corrected an issue which caused incorrect values to be displayed when using negative table values

with the 4-20mA bridge.

Version 3.14 (July 19, 2010)

• Corrected a problem which sometimes left the phone LED lit when it should have been off.
• Corrected two problems on the web page which affected IP alarms. When creating a new IP alarm

sometimes more than one would be added. Also, when deleting an IP alarm sometimes all of the
information would not be deleted causing the alarm to continue to occur after deleting it.

Version 3.13 (April 23, 2010)

• Added support for IMS-4816 External Temperature Probe
• Improved Wireless Node functionality
• Corrected issue which caused RAS dial-up to fail (requires System Support v2.21)

Version 3.10 (December 4, 2009)

• Added support for the IMS-4200 Wireless Node & Wireless Sensors
• Fixed a problem with IP Alarms which caused the Reset Time feature to fail.
• Fixed a problem viewing the node input values when using more than 10 nodes with a (minimum)

10 second status refresh interval configured on each. Under these conditions the input status would
not update for all nodes.

• Improved Node trouble alarm descriptions.

Version 3.0.8 (April 17, 2009)

• Added support for the IMS-4310 Dual Relay Output Module

Version 3.0.7 (March 7, 2009)

• Fixed issue which caused two-way e-mail commands to fail when sending from g-mail, hotmail,

yahoo, and other online e-mail applications

Version 3.06 (December 17, 2008)

• Corrected issue involving the Reset–to–Defaults option in the local configuration menu.

Version 3.05 (December 5, 2008)

• Corrected issue involving the display of the IP Alarm Last Response from Nodes when multiple

Nodes were configured with IP Alarms and the Status Refresh was set to the minimum of 10
seconds on each device.

• Corrected issue which prevented nodes from flash updating.

Version 3.04 (November 18, 2008)

• Updated firmware to properly display free memory available on the Voice screen within

ConsoleView.

Version 3.02 (October 15, 2008)

• Corrected an issue that could potentially occur when changing the node IP address using

ConsoleView. Under certain conditions the node could reconnect to the wrong programming slot in
the host, thus acquiring incorrect programming.

Version 3.01 (June 1, 2008)

• Corrected alarm processing issue when using the Ultra–Low Temperature Sensor.

Version 3.00 (May 12, 2008)

• Added programming support for new IMS-series sensors: Ultra–Low Temperature Sensor, 15A

Current Sensor and 20A Current Sensor.

• Added ability to allow custom table values for 4–20ma sensors.