beautypg.com

Important – Schwank comfortSchwank - Powder STW-JZ User Manual

Page 18

background image

18

SPW-JZ, STW-JZ(2) / IWP, IW(2) I&O Manual

IM101229

RL: 13A

RD: MAY 2014

5) Please NOTE that each hanger has a ‘flat’ side and a ‘cavity’ side – FIGURE 6

a) Starting at the burner end of the heater: all hangers except the last plate hanger are ori-

ented with the cavity side of the hanger facing toward the burner end

b) The cavity side of only the vent end plate hanger faces the vent - FIGURE 6

Refer to Figures on next pages, then proceed to Section 9. Burner and Tube Installation

Intermediate Webbed

Hanger (note: cavity side

always faces Burner).

Use solid End Plate Hanger

at Burner and Vent ends

(note cavity side faces

outward from tube)

FIGURE 6 END PLATE & WEBBED HANGERS

Bu

rne

r

IMPORTANT

FIGURE 7 TYPICAL HANGER & SUPPORT SPACING

1. Burner Assembly
2. Flange Adapter
3. Flanged Tube
4. Swaged Tube
5. Vent termination

(optional; wall or roof)

6. End Plate Hanger
7. Webbed Hanger
8. Hanging Chains
9. Focus Shield Reflector
10. Reflector Stabilizer

10

10

116” (295 cm)

The distance between the
tube flange and face of
the plate hanger must be
2.5” (6 cm)

Angle the burner suspension
chain back over the burner to
allow system expansion

116” (295 cm)

6.5” (16.5 cm)