S&S Cycle Super E and G Series Shorty Carburetors - Manual (Page 6)

6
3- Shovel, 1980 to 1984 and Sportster® models 1980 to 1985 - Screw crankcase breather vent elbow fitting into hole in air cleaner backplate
and angle downward as shown in Picture 7.
4- On 1983 and 1984 shovel engines press plug into other hole on left.
5- Assemble fast idle mechanism as shown in Figure A. On current backplates the pivot point for the enrichener does not have a screw
holding it; a boss has been cast onto the backplate to replace this.
B- 1984-’92 Evolution® big twin engines
1- Install plug into hole on left in air cleaner backplate as shown in Picture 8.
2- Screw vent hose elbow fitting into remaining hole at right. See Picture 8.
3- Refer to step 5 above about assembling the fast idle mechanism.
C- 1986 to 1990 Sportster models
1- Install plug into hole on right in air cleaner backplate as shown in Picture 9.
2- Screw vent hose nipple fitting into remaining hole at left. See Picture 9. Elbow fitting supplied in kit may also be used in this location if
required.
3- Assemble fast idle mechanism as shown in Figure A. On current backplates the pivot point for the enrichener does not have a screw
holding it; a boss has been cast onto the backplate to replace this.
D- 1993-up big twin & 1991-up Harley-Davidson® Sportster®
1- Install plugs into both holes in air cleaner backplate as shown in Picture 10.
2- Refer to step 3 above about assembling the fast idle mechanism.
E- Buell® motorcycles, 1994 and '02 - Refer to step 3 above about assembling the fast idle mechanism.
Picture 7 Figure A
Picture 8 Figure 9
Picture 10