Retsch PM 200 User Manual
Retsch Equipment
Table of contents
Document Outline
- Information on these operating instructions
- Safety
- Confirmation
- Technical specifications
- Transport and assembly
- Operation
- Connect the power
- Opening / closing / emergency unlocking of the grinding chamber
- Inserting and clamping grinding bowls in the PM100
- Removing the grinding bowl fastening device in the PM100
- Tightening and unscrewing the grinding bowl fastening device using a counter spanner
- Safety Instructions for starting the PM 100
- Balancing – only required for the PM100
- Balancing – only for PM 100 with additional balance weight
- Inserting and clamping grinding bowls in the PM200
- Tightening and loosening the grinding bowl clamping fixture using the counter spanner
- Safety instructions for starting the PM 200
- Suitable grinding bowls for the PM100
- Stacking of 50 ml milling cups of type “C”
- Suitable grinding bowls for the PM200
- Stacking 50ml grinding bowls of type "C"
- Handling grinding bowls of type "C"
- Grinding bowl identification
- Tips for ultra-fine milling
- Use of the closing device for milling cups
- Operation via the PM100/200 display unit
- NO
- Error messages on the display
- General points