Purenex FLECK 5600SXT METER WATER SOFTENER SYSTEMS - Manual (Page 9)

- 9 -
FIGURE 20 FIGURE 21
• Wrap electrical tape over the drain tubing to prevent a tubing split, and clamp the
tubing securely into place with the included blue clamp as shown in Figure 22
below.
FIGURE 22
• Connect the other end of this drain line tubing SECURELY to a standpipe or
drain in accordance with all local plumbing codes.
NOTE: Be sure that the
drain line is securely in place before the use of the water softener system.
When the system regenerates, there will be increased flow via this tubing,
which may cause the tubing to become loose.
Programming the Fleck 5600SXT Meter Valve:
• Before start-up a few simple steps must be followed to program the Fleck
5600SXT Meter Valve.
• It will be important to know what your water’s Hardness and Iron content is
before doing this programming procedure. If you do not know your water
hardness, or if you are unsure, you may wish to have it tested by sending us a
sample for testing, or by taking a sample to a local pool supply, or hardware store.