Purenex FLECK 5600SXT METER WATER SOFTENER SYSTEMS - Manual (Page 14)

- 14 -
• The display may now show “FM / t0.7” as shown in figure 40 below. (This
indicates Flow Meter type 3/4" Turbine)
Do not change this value, and press
the “Extra Cycle Button” once to continue – if this value is different, use the
“UP” or “DOWN” buttons to change this.
• The system will now exit the Master Programming mode, and the display should
now show the time of day, flowed by the new number of gallons remaining, as
shown in figure 41 below.
Change the time of day by pressing and holding the
“UP” or “DOWN” button until the proper time setting is shown. Note that
there is a “PM” light indicator to differentiate between AM and PM times.
FIGURE 40 FIGURE 41
• Congratuations! Your new 5600SXT system is now programmed and ready for
operation. Please move on to the next section on the following page to initialize
and start-up your system.