Purenex FLECK 5600SXT METER WATER SOFTENER SYSTEMS - Manual (Page 11)

- 11 -
• The display should now show “7VT / St1b”as shown in figure 27 below. (This
indicates Valve Type 5600 Mode)
Do not change this value, and press the
“Extra Cycle Button” once to continue
.
• The display should now show “CT / Fd” as shown in figure 28. (This indicates
Control Type METER Delayed Format)
Do not change this value, and press the
“Extra Cycle Button” once to continue
.
FIGURE 27 FIGURE 28
• The display should now show “NT / - - - 1” as shown in figure 29 below. (This
indicates Number of Tanks is Single)
Do not change this value, and press the
“Extra Cycle Button” once to continue
.
• The display should now show “C / 32.0” as shown in figure 30 below. (This
indicates the Capacity is 32,000 grains)
Use the “UP” or “DOWN” button to
change this value to the size of your system, and press the “Extra Cycle
Button” once to continue when finished.
FIGURE 29 FIGURE 30
• The display should now show “H / 20” as shown in figure 31 below. (This
indicates the Hardness is 20 grains)
Use the “UP” or “DOWN” button to
change this value to the total hardness of you water (as calculated on page
10), and press the “Extra Cycle Button” once to continue when finished.
FIGURE 31