MacDon 5020 Mower Conditioner - Manual (Page 9)

9
SPECIFICATIONS
DIMENSIONS
12 FT. 14 FT. 16 FT.
Overall Width:
Transport Position 13.5 ft. (4103 mm) 15.5 ft. (4713 mm) 17.5 ft. (5323 mm)
Field Position 18.1 ft. (5531 mm) 21.1 ft. (6446 mm) 24.1 ft. (7360 mm)
Overall Length:
Transport Position 20.7 ft. (6320 mm) 22.1 ft. (6740 mm) 24.9 ft. (7573 mm)
Field Position 15.8 ft. (4816 mm) 16.3 ft. (4975 mm) 18.2 ft. (5557 mm)
Overall Height
Transport Position 6.2 ft. (1896 mm)
Field Position 6.2 ft. (1896 mm)
Weight
5900 lbs. (2675 kg) 6250 lbs. (2835 kg) 6623 lbs. (3005 kg)
CUTTERBAR
Cutterbar Width
12.25 ft. (3734 mm) 14.25 ft. (4343 mm) 16.25 ft. (4953 mm)
Cutting Height (on skids)
1.5 to 4 in. (38 to 100 mm)
at 8° guard angle
Guard (Header) Angle (adjustable)
6° to 11.5° below horizontal
Cutterbar Range
2.0 in. below ground to 21 in. above ground
at 8° guard angle (to guard tip) (-50 mm to +533 mm)
MAIN DRIVE
540 or 1000 RPM PTO tractor driven pump
to hydraulic motor driving primary shaft
Rear Countershaft Speed 1156 RPM *
SICKLE
Drive Type
Belt driven wobble box (enclosed oil bath)
Speed
1560 strokes or 780 cycles per minute *
Stroke
3 in. (76 mm)
Sections
Over-serrated, low shoulder
Guards
Double heat treated, forged steel
REEL
Drive Type
V-belt drive from R/H auger shaft
to chain final drive
Reel Type
5 bats (4 or 6 bats optional),
replaceable steel pick-up tines,
cam action, polymer tine tube bearings
Radius
22 in. (1560 mm) to finger tip
Speed
72 RPM as assembled / 59 RPM with
pulley exchange / 66 RPM optional *
NOTE: Specifications listed only under 14 ft. column are common to all sizes.
* All speeds are in no-load condition at rated tractor RPM.