MacDon R85 Rotary Disc 13 Foot Self-Propelled Windrower Header - Manual (Page 114)

MAINTENANCE AND SERVICING
7.5.2 Break-In Inspections
Timing Item Refer to
Check for loose hardware. Tighten
to required torque.
Section 7.2 Torque Specifications, page 92 .
At 5 hours
Check drive belt tension.
At 25 hours Check drive belt tension.
Check drivebelt tension.
Inspecting the Conditioner Drive Belt, page 138 .
Change cutterbar lubricant.
Section 7.5.8 Lubricating the Cutterbar, page 113 . Use
Only Specified Amount. Do NOT overfill.
At 50 hours
Change bevel gearbox lubricant. Changing the Bevel Gearbox Lubricant, page 137 .
Change cutterbar lubricant. Section 7.5.8 Lubricating the Cutterbar, page 113 . At 150 hours
Change bevel gearbox lubricant. Changing the Bevel Gearbox Lubricant, page 137 .
7.5.3 Preseason/Annual Service
CAUTION
• Review the operator’s manual to refresh your memory on safety and operating recommendations.
• Review all safety signs and other decals on the header and note hazard areas.
• Be sure all shields and guards are properly installed and secured. Never alter or remove
safety equipment.
• Be sure you understand and have practiced safe use of all controls. Know the capacity and the
operating characteristics of the machine.
• Check the first aid kit and fire extinguisher. Know where they are and how to use them.
Perform the following at the beginning of each operating season:
• Lubricate machine completely. Refer to Section 7.5.5 Lubrication and Servicing, page 107 .
• Perform all annual maintenance. Refer to Section 7.5.1 Maintenance Schedule/Record, page 104 .
169455
106
Rev. E