MacDon 962 Harvest Header - Manual (Page 64)

64
UNLOADING & ASSEMBLY
INSTALL GAUGE WHEEL / TRANSPORT OPTION
30 & 36 FT.
NOTE: These instructions apply to the gauge
wheels with transport option. For instructions for
installing the standard gauge wheel package, see
previous page.
1. Remove chain hooks and move lifting vehicle
to rear of header. Attach chain to center link
anchor on frame tube and raise rear of header.
2. Identify right and left wheel supports: Left
wheel support has single wheel caster, right
wheel support is attached to dual wheel beam.
3. Front end of gauge wheel spring assembly was
attached to header outer legs before header
was lowered (see page 62). Attach clevis at
other end of spring to plate (C) at left and right
wheel supports, using 5/8 hex head bolt and
lock nut.
NOTE: Do not collapse clevis by over-tightening
hardware. Clevis must be free to rotate.
NOTE: For ease of installing right wheel support,
remove 1/2 inch bolt (H, next page) securing pivot
shaft, allowing removal of dual wheel beam.
4. Ensure plastic bushings (D) are installed (2 per
support). Position wheel support assembly in
header leg and install tube (E) from outside
header leg through wheel support. Attach two
brackets (F) with 1/2 x 1 ¼ inch bolts and nuts
to the brackets welded to header leg.
IMPORTANT: Tighten to 80 ft. lbs. (110 N
⋅
m).
Be sure that welded tab (G) on tube (E) is
engaged in slot in bracket (F) on one side.
Repeat at other gauge wheel support.
ENGAGE TAB IN BRACKET SLOT
INSTALL WHEEL SUPPORTS (L/H SHOWN)