B. included hardware – Pololu Dual MC33926 User Manual
Page 4
Pololu dual MC33926 motor driver shield for
Arduino with included hardware.
1.b. Included Hardware
This motor driver board ships with all of the surface-
mount parts populated. However, soldering is required
for assembly of the included through-hole parts. The
following through-hole parts are included:
• one extended/stackable 1×10 female header (for
Arduino shields)
• two extended/stackable 1×8 female headers (for
Arduino shields)
• two extended/stackable 1×6 female headers (for
Arduino shields)
• three
(for board
power and motor outputs)
• 25-pin
A
(for optionally supplying shield power to Arduino)
is also included.
You can solder the terminal blocks to the six large through-holes to make your motor and motor power
connections, or you can break off a 12×1 section of the 0.1″ header strip and solder it into the smaller through-
holes that border these larger holes. Note, however, that each header pin pair is only rated for a combined 6 A, so
for higher-power applications, the terminal blocks should be used or thick wires should be soldered directly to the
board.
When not using this board as an Arduino shield, you can solder the 0.1″ headers to the logic connections along
the left side of the board to enable use with
or
or you can solder wires directly to the board for more
compact installations. Note that motor and motor power connections should not be made through a breadboard.
The mounting hole is intended for use with
(not included).
An
is not included.
Pololu Dual MC33926 Motor Driver Shield User's Guide
© 2001–2013 Pololu Corporation
1. Overview
Page 4 of 24