PIAA Bulb - Manual (Page 2)

1. Turn off vehicle, set parking brake, and disconnect negative
battery cable.
2. Locate the bulb(s) you wish to replace.
3. Remove the plug from the harness that connects to the
back of the bulb.
4. Remove the clip(s) and or spring that holds the bulb
in the lamp.
5. Carefully remove bulb, do not touch or bump it on anything
if you plan on reusing it later. Do not break bulb, it is under
pressure and may burst causing personal injury.
6. Remove the new PIAA bulb from its container, touching
only the metal or plastic base.
7. Insert the new bulb in the reverse of how you removed the
old bulb.
8. Make sure you insert the bulb all the way into the bulb seat
at the back of the lamp.
9. Fasten the clip(s) or spring that holds the bulb in place.
10. Make sure the connector is clean and undamaged then plug
it into the back of the bulb.
11. Reconnect negative battery cable.
INSTALLATION
For detailed instructions on your vehicle
consult your vehicle owner's manual.