PIAA RS800 H.I.D. Shock Lamp User Manual
Page 9
8.
• Use PIAA H.I.D. bulb (D2S).
• Check for correct side of the bulb spring for proper installation.
• After connection is done, make sure that the word "LOCK" on
the socket is properly oriented.
(5) Remove two (+) screws at the bulb spring to remove H.I.D. bulb.
(6) Engage the H.I.D. bulb notch to the lug on the bulb holder, then fix with
the bulb spring and (+) screw.
H.I.D. bulb
Bulb holder tab
H.I.D. bulb notch
Bulb spring
Bulb spring
(+) screw
(7) Engage the igniter notch to the lug on the bulb, then insert and turn to the
right to lock.
(8) Attach the water proofing cover and the clip.
(9) Set the tab at the top of the lens unit to the top of the lamp body, then fix
with the screw.
• Securely install the bulb socket to the bulb. If not properly installed, abnormal
electric discharge occurs when the lamp switch is turned on. Electrification and
melting of bulb socket might occur, and it is very dangerous.
(Max. voltage of 20,000V)
Top view
Bulb spring
convex part
H.I.D. bulb
The convexed side of the bulb
spring should meet the bulb.