PIAA 510 Series - Manual (Page 3)

TOOLS
Phillips driver (medium)
Phillips driver (short)
Pliers
Diagonal cutters
LAMP
INSTALLATION
• The installation area must be clean, and level with enough working space to do
the job without distractions.
• The PIAA 510 lamps may be mounted upright or hanging down. It is very
important that you make sure that the “PIAA” etched in the glass reads right side
up. If it is not you must follow the “Lamp assembly/disassembly diagram” to flip
the lens over.
• For the lamp system to function properly the supplied PIAA harness must be used.
• When mounting the lamps mount them in such a place that they are free
of obstructions.
• Do not modify the lamp system in any way or it will void the warranty.
• Do not mount the lamp system in a place that may obstruct an existing
automotive function.
• Do not mount the lamps in a place that they will come in contact with the
road or curbs.
• When a mounting location is decided upon a 10mm hole will be needed to
mount the lamp with the supplied mounting hardware. If a hole is not available
one will have to be drilled. (Contact your local PIAA dealer for custom
installation kits for many vehicles.)
• When lamp is mounted make sure to leave at least 1/8 inch clearance around the
lamp to avoid heat damage to front spoilers and/or grills.
Vinyl electrical tape