Paxton Fail closed 12V DC electric release kit - Manual

Ins-30068 Fail closed 12V DC electric release kit
Fail closed release - If there is no power supplied to the lock, the door is locked.
Operation - The unit is designed to operate at 12V DC continuous or non-continous operation.
Fitting
Rim Mortice
Door frame Door frame
Cover screws 8 x 1” countersink screws
1. Remove the cover of the electric release and connect the 2 core cables to the terminals inside the release.
(polarity is not important)
2. Replace the cover. If you are using the rim fitting, do not refit the side plate - this must be discarded.
3. Rim: Secure the release on the door jamb using the cover and screws provided.
Mortice: Secure the release into the door jamb using the countersink screws provided.
09/02/2010
Technical Support
Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)
Saturday from 09:00 - 13:00 (GMT)
Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/
01273 811011 [email protected]
Ensure that the latch is not a tight fit against the rotating release or it may
cause the mechanism to jam.
Release
Release
Paxton