Paxton 2A/12V DC boxed power supply - Manual (Page 2)

1. Screws and wall plugs are provided in a fitting
kit. With reference to the diagrams, determine
where the top, central mounting position is
required and drill a hole suitable for a No 8 wall
plug.
2. Tap in one of the wall plugs.
3. Put in one of the long screws, leaving a
suitable gap to the wall surface and slide the
cabinet over it.
4. Mark the hole positions for the lower 2 screws.
5. Remove the cabinet and drill the additional
holes.
6. Tap in the 2 wall plugs and hang the cabinet
back onto the top screw.
7. Secure the cabinet with the 2 lower screws.
8. Tighten the top screw.
Fitting
68mm
116mm
25mm
320mm
232mm
268mm
68mm
Metal Cabinet
A detachable figure 8 power cable is
provided with the unit. This is pre-stripped
at one end for connection to a fused spur.
Anchor points are supplied inside the case
to secure the incoming mains cable. (cable
tidy/ties are provided) There are also
'knock-outs' in the case to allow convenient
access for the cable.
Ensure that the supplied compression gland
is used when passing the mains cable
through any holes in the cabinet.
AC Mains Connection
Statement of Conformity
The Low Voltage (LVD) Directive - 2006/95/EC
The Electro-Magnetic Compatibility (EMC) Directive - 2004/108/EC
The Restriction of Hazardous Substances (RoHS) Directive - 2002/95/EC
Plastic Cabinet
98mm
118mm
18mm
320mm
236mm
284mm
98mm
The power supply is double insulated
and requires no additional earth
connection.
The PSU's battery function will not
work until this unit has first been
connected to the mains supply. It is
the loss of this supply that switches the
unit to battery power.
This product is not suitable for retail sale. All warranties are
invalid if this product is not installed by a competent person.