Paxton 24V AC/DC power supply with battery charger - Manual (Page 2)

Page 2
1. Screws and wall plugs are provided in a fitting kit.
With reference to the diagrams, determine where
the top, central mounting position is required and
drill a hole suitable for a No 8 wall plug.
2. Tap in one of the wall plugs.
3. Put in one of the long screws, leaving a suitable
gap to the wall surface in order to slot the cabinet
over it.
4. Mark the hole positions for the lower 2 screws.
5. Remove the cabinet and drill the additional holes.
6. Tap in the 2 wall plugs and hang the cabinet back
onto the top screw.
7. Secure the cabinet with the 2 lower screws.
8. Tighten the top screw.
Fitting
Metal Cabinet
Plastic Cabinet
This product is not suitable for retail sale.
All warranties are invalid if this product is
not installed by a competent person.
Input Connection
Anchor points are supplied inside the case to
secure the incoming supply cable (cable ties are
provided).There are also 'knock-outs' in the case
to allow convenient access for the cable.
Use the supplied gland or grommet when passing
the input cable through any holes in the cabinet.
The battery backup function will not work until
this unit has first been connected to the input
supply. It is the loss of this supply that switches
the unit to battery power.
The input cable must be passed around
the supplied Ferrite core.
This should be fitted within 5 cm of the
connection with the power supply.
232 mm
68 mm
116 mm
25 mm
320 mm
268 mm
68 mm
136 mm
236 mm
196 mm
118 mm
18 mm
320 mm
284 mm
98 mm 98 mm