Wiring the system – Paxton PROXIMITY energy saving reader demonstration kit User Manual
Page 4
Connect the reader to the Switch 2 as per instruction Ins-30119 and power up the Switch 2.
The controller will beep at 3 times per second to indicate that it requires enrolling.
To set the system in toggle mode, present the relay toggle card to the reader.
The control unit will beep twice and the GREEN and AMBER LEDs will go out.
The RED LED will remain lit.
1. Wiring the system
Remove the Enrolment card from the card pack and present it to the reader.
PR
OX
IM
IT
Y
en
ro
lm
en
t c
ar
d
1. A
t installation, present thi
s
card
to th
e reader t
o v
alidat
e
th
e tok
ens in th
is pack.
2. T
o re-
va
lidate a us
er tok
en,
pres
ent this enrolment card
to the
reader
follo
wed b
y the
u
ser tok
en.
1.
At in
sta
llat
ion
, p
res
en
t th
is c
ard
to
th
e
rea
de
r to
va
lida
te th
e t
ok
en
s in
th
is p
ack
2.
To re
-va
lida
te a
us
er
tok
en
pr
ese
nt th
is
en
rolm
en
t c
ard
to
th
e r
ea
der
fo
llow
ed
by
th
e
use
r to
ken
Pa
xto
n A
cce
ss
FUNCTION CARD
en
rolm
en
t c
ard
Mo
re i
nfo
:
htt
p:/
/pa
xto
n.i
nfo
/74
Setting up your energy saving reader system
4. Operation
3. Relay toggle card
2. Enrolment
+
-
Reader
or
Keypad
D
oor
rela
y
Power
Alarm
12V
Red LED
Amber LED
Bell
12V
0V
N.C.
N.O.
COM
Green LED
Data
Ca
ution:
F
or
12V
d.c
rea
ders
only
.
F
or
correct
connection of old 5V
readers, please ref
er
to
instructions.
Clock
Exit
Inputs
Contact
Media Detect
0V
PLACE SERIAL
NUMBER
LABEL HERE
Switch2
http://paxton.info/107
123456
The above diagram shows the Switch2 and energy saving reader configured to control a room light.
This could be used in a meeting room to ensure that the lights are off when the room is not occupied.
NOTE: AC Mains voltage must NOT be directly connected to the controller.
The kit supplied here demonstrates these principles.
When a user card is placed in the reader, the relay output will change state and the GREEN LED will come on by
itself. When the card is removed again the relay state will change back and the RED LED will illuminate.
Paxton Access
Rela
y toggle card
Swipe
or
present
this
card
to
change
the
action
of
the
output
rela
y from
a time
interv
al
to
toggle.
A v
alid
card
will
now
close
the
rela
y contacts.
They
sta
y closed
until
another
valid
card
is swiped
or
presented.
The Switch 2 controller must be used in toggle mode and provides a set of normally open or normally closed relay
contacts to control the attached hardware. This means that the relay will stay turned on for as long as a user card
remains in the reader.
Equipment to be switched
(not supplied)