Pavement Ends 51380 Replay - Manual (Page 3)

51380 pg 3 1206 Rev. A
Step Five
S ECURE R EAR B OW
Make sure that the middle bow is forward,
up against the Sport Bar.
Open the header and push it back.
Lift up the rear of the top and slip the Rear
Bow into the rear corners of the fabric. Snap
the 5 snaps in the fabric to the snap heads
on the bow.
Step Six
S ECURE R EAR C ORNERS
Locate the plastic strip sewn into the bottom of the rear
legs of the top. Slip the plastic strip into the retainer on
the rear corners of the vehicle. The front edge of the
plastic strip should be far enough forward to touch the
stop in the retainer.
Step Seven
S
ECURE
T
ENSION
S
TRAP
Pull the Tension Strap above the doors, through
the Tension Assembly and snap it to itself.
Front
Center
Flap
Sport Bar
Middle Bow -
Forward against
Sport Bar
View from inside top - toward rear
Rear
Snap fabric to
Rear Bow
Rear
Bow
Rear
Side
Retainer
Plastic Strip - should
meet stop in retainer
Plastic Strip - Slip
under retainer
Tension Assembly
Front
Door Opening Pull Strap through and
snap to itself
Front
Snap Center Flap on
each side of Dome Light
Wrap fl ap around
Middle Bow
Fasten Hook
and Loop
View from inside top - toward rear
Rear
Rear Bow
Sport Bar
Step Eight
S ECURE C ENTER F LAPS
Close and clamp the header to the windshield.
Inside the vehicle, snap the Center Flap to the snap heads on the
Sport Bar. The fl ap will snap on each side of the Dome Light.
Locate the fl ap on the inside of the top just behind the Center Bar.
Wrap the fl ap around the middle bow and fasten the hook and
loop, sewn to the fl ap.