Pavement Ends 51380 Replay - Manual (Page 2)

51380 pg 2 1206 Rev. A
Parts List
Fabric Top Qty - 1
Quarter Window, Right Qty - 1
Quarter Window, Left Qty - 1
Rear Window Qty - 1
Step One
O PEN H EADER
Remove the old top.
Orient the top of the vehicle. The pocket sewn into
the top should be toward the front.
To open the header, push the red buttons on each
side of the latch that attaches the header to the
windshield. Open the header and push it back.
Step Two
S ECURE T OP TO H EADER
Slip the pocket sewn into the front of the top over
the front edge of the header. Snap the fi ve snaps
along the pocket to the snap heads on the header.
Step Three
S NAP C ENTER F LAP
Push the header forward to close it, but do not
latch it at this time.
Make sure that the snaps on the center fl ap on
the inside of the top are in front of the Sport Bar
and the hook and loop sewn to the fl ap is behind
the Sport Bar.
Step Four
T HREAD S TRAPS THROUGH T ENSION A SSEMBLY
Locate the straps sewn to the top above
the door on each side of the vehicle.
Thread the straps through the tension
assembly on each side of the vehicle.
Do not snap at this time.
Push red buttons on latch
to release header
Sun Visor
Header
Windshield
Header
Pocket - Slip over front
of Header
Snap Pocket to Header
Front
Sun Visor
Center Flap - Must be
in front of Sport Bar
Sport Bar
Dome Light
Front
Tension
Assembly
Top Fabric
Strap - Thread
through Tension
Assembly