BT In Touch 2000 - Manual (Page 17)

17
User
Phone
&
P
endant
Open the battery cover on the underside of
your BT In Touch 2000 User Phone. Insert the
6 x AA Alkaline batteries.
IMPORTANT
The batteries act as a stand-by power source in the
event of the mains power being disconnected. If at
any time you find that the battery power has been
used, you should immediately replace all existing
batteries with new batteries. This will ensure that
your phone has the maximum stand-by power time.
The batteries taken from your BT In Touch Phone
can then be used for any other electrical appliance
requiring battery power.
3 Connect the telephone
line cord
If you do not have a modern phone socket,
then you can call BT on Freefone 0800 800 150
and ask for a BT engineer to come and fit the
correct type. This is a chargeable service.
4 Select ringer volume
The ringer volume switch is on the underside
of your phone.
Set the volume of the ringer to High, Low
or Off.
This should be done before you attach the base
stand for either raised or wall mounted positions.
5 Select ringer tone
The ringer tone switch is on the underside of
your phone.
This switch allows you to select the pitch
required for the ringer.
R1: for a low-pitched tone
R2: for a medium-pitched tone
R3: for a high-pitched tone
This should be done before you attach the base
stand for raised or wall-mounted positions.
RINGER
VOLUME
HI
LOW
OFF
RINGER
R1
R2
R3